Features:

  • Split design allows for easier installation
  • Replacement can reduce front end noise
  • Restores like-new steering and handling
  • Bushings are engineered to provide long life and dependability
  • Incorporates proven design and engineering features
  • Inner sleeve is phosphate coated for corrosion protection
Go ahead and replace, takes minutes to do

Moog makes excellent products of high quality and performance. I have a 2004 Wrangler TJ and it took me all of about 15 min start to finish to remove the old dry rotted factory bushings and install these new Moog ones. I used an impact wrench to make job easier, but a breaker bar/ratchet would work too. When I had the brackets off, I lightly sanded/cleaned them and repainted them to freshen things up. Jeep handles very well now. I noticed a difference immediately.

Great fit, easy install

The bushings on my 1998 Jeep Wrangler rear sway bar were showing their age. Replaced them with Moog bushings - these were a great fit and finish. The old bushings were allowing a slight amount of play because of hardened rubber and both had some cracking after 21 years of use. Replacing the old with the new took about 45 minutes.

1998 Wrangler, perfect replacement!

The single split design is good for installation, although warming them up is very helpful! It was cold outside when I started the project, and ended up taking them inside to warm them up. The polyurethane gets a bit more pliable when warm. A large flat bladed screwdriver gave me just enough split to slip them over the bar. Perfect fit on my 1998 Wrangler, rear swaybar. .

2000 Jeep Cherokee XJ Rear Sway Bar

Great price, fast delivery, good fit, and very solid build. A lot of people pull the rear sway bar off the XJ, but I don't do rock crawling or anything crazy. But I do have a 3" lift and 31's, mostly trail runs and some mud and a lot of NYC potholes, so I want the rear sway bar on the Jeep. Very pleased.

Good upgrade for worn out bushings

These were easy to install. They're a tight fit on the sway bar and don't leave any slop, but they allow the sway bar to move and twist properly.

Thought these were for the front

I ordered these to replace the front but they do not fit, for rear only, I did use them to replace the rear and fit just like stock, bit of advise warm them up before install makes it easier.

Hand thread on installation!

Hand thread the bolts onto the frame in the beginning. I cross threaded one bolt, had to tap/die the screw hole to get it right. I used anti-seize on it too for the future if needed.

Definitely tightened up the ride on the 03 TJ

Easy to install, low cost, definite ride improvement.

Perfect

Perfect fit for my 2002 jeep wrangler rear sway bar. Easy install, 10 minutes top. Sway bar feels nice and solid again with no noises.

very good

good replacement for the knackered ones on my TJ, easy to fit and tightened up the sway bar.

Full Reviews