Features:

  • Thermoplastic bushings are resistant to heat, wear, salt, road grime and oils.
  • Includes universal mounting bracket.
Much Better than other aftermarket units

I replaced my bushings 2 years ago with cheaper units and they were already shot. I went with these units this time and the quality is evident. They fit much better, go on very easy, and look like they will last several years longer. It helped make my front end handle like a new car again. Helpful tip is to jack you front end up and put a jack stand on each side to keep the front tires off the ground. Then put the jack under the control arm of the side you replace first and jack until the arm begins to lift, but not enough to take the weight off the jack stand. You can now loosen the bushing from the sway bar without the bar releasing all of its tension on you. Now lower the jack just enough to drop the bushing for easy replacement. Once the new one is in place jack the control arm up again until the bushing is in place, add the bolts, and tighten. Repeat on opposite side and your done in 20 minutes tops.

Easy Install for '01 Suburban 1500

Bolts holding old bushings are 10mm, and reusable. You will need the short ratchet extension for the back bolt. You will also need a long screwdriver to reposition the bar for removal of the old bushing. WD-40 will help unstick the rubber on the bar and frame, and assist with installing the new. Less than an hour. You also need ramps to raise the front end. The new brackets are necessary to fit the new bushings. Cadmium plated for rust resistance.

Fit 1994 Winnebago Brave P30 Front 1.25" Sway Bar Perfect

High quality eom replacement part. These Bushings are bigger / better than original. Easy to change because bushing have a slit that opens up to allow you to get bushing hooked onto sway bar, meaning you won’t have to drop the bar and thread Bushings onto the bar, the silt opens and bushing goes over bar!

Good replacement for 1997 GMC Sierra.

Replaced the bushings on my 1997 GMC Sierra. Fit same as the originals

It corrected the issue.

Other reviews informed me that it would not fit my vehicle. It was not the actual item required but my husband made it fit. It was used to replace the stabilizer bar rubbers.

Fit grateful

Fit great to replace CPP sway bar Polly bushings on 72 C10. Hope they hold up better than CPP which was in 4 yrs, always garaged

good

these would have been good but there are 3 different sizes for my truck and these were wrong. you really need to measure you trucks bar

Great buy

Good price for these. Holds the sway bar nice and tight, now my truck takes corners flatter. It feels much safer now.

Pictures don't do the strength of the bracket Justice

Let me start off with saying I love Moog suspension parts and the rubber appears to be of good quality as well as the bracket which is.

Perfect for 1995 P30 motorhome

Great shipping, installed very easily, and quieted down the noise in my front end. Perfect for my 1995 P30 motorhome.

Full Reviews