Features:

  • "usa standard replacement outer stub for gm dana 60 differential, 12", 35 spline"
  • Fit type: Vehicle Specific
  • Package Length: 12.0 inches
  • item package weight: 8.25 pounds
So far so good, ZJ d30

Direct swap on my 95 ZJ d30 27sp. Came with inner axle seals( I did not know that). However, it does not have the ABS tone ring. If you want that, either swap them over from oem units or purchase them. So far, very happy with the shafts and would buy them again. I snapped a CV joint on an OEM shaft, I do not see that happening now.

Great product unbelievable price

I use this to replace a damaged axle on my 98 Chevy S10 4 wheel drive the product fit perfectly I would recommend that you watch the manufacturer's video to determine the correct axle for your vehicle I am very happy with the price under $100 at the time I bought it I am even more impressed that it's made in the USA

Quality piece

This is a quality product from Yukon. These are their seconds or blems but there is nothing structurally wrong with them. Why pay double the price for the same axle?! Splines are straight, strong and properly hardened. Highly recommend USA Standard Gear to anyone wanting good axles; if you need a ring and pinion I would stay clear if you are looking for a quiet set of gears, again they are seconds from Yukon.

For perfect well worth it compared to others

Had issues with ups getting product since it was dropped off at the wrong house but that's not the sellers fault. As for the product it looked great very well made for perfect and most of all with new bearing this axle fixed the issue no more vibration and the leak went away. Thank You

Fit 1995 Jeep YJ perfect

Fit 1995 YJ Jeep, left rear Dana 35 perfect. Well made, well packed, thanks! Don't forget to get new studs, or be prepared to remove and reinstall the old ones (a pneumatic air hammer really helped....use anti-seize to lube the threads/splines of the studs). I used it with new Yukon Bearings/Seals no problem.

Can’t go wrong at this price.

Great price on some chromoly shafts for my Dana 30. Only one trip on them so far but held up to my 35’s.

Fits my 1979 Oldsmobile Cutlass

I have so far been very impressed and so far no issues and my cutlass now drives smoother than ever. The axle was the same size in length and overall thickness . 7'5' rear end fits 26 spline no problem. FYI use a slide hammer for the old bearing , otherwise its a Brutal pain in the butt to remove by hand

Better than stock

I am positive this is made by Yukon. Very nice product for my 79 Bronco worked perfect on my ford 9”

USA made

hands down the perfect fit and way cheaper than local parts store

Five Stars

Perfect fit for a '97 F350 Dana 60 front axle (aftermarket lockouts for 35 splines).

Full Reviews