Features:

  • Designed for exact fit in the vehicle's Original Equipment heater casing
  • Unit is leak tested to ensure product quality at installation
  • High density fin count for maximum heat dissipation
  • Precisely tooled tanks for strength and durability
  • Optimum tube pitch spacing to maximize heat transfer
Great product. I will buy again if this one fails.

It went in great. Secret if you have to replace in a 2010 dodge journey. Don't disassemble the Dashboard. Put a open trash bag under the hoses in the drivers floorboard. With a cold engine, cut the tubes in the floorboard. Pull out old one after water drains into bag. Cut the hoses on new one to match. Slide in. Connect with 5/8ths heater hose. Fixed. Easy to fix next time. They fail because of a design flaw in location choice by dodge. There are YouTube videos that show how to do this. Its easy and only a 30 minute job. I used a grinder. Check for wires first. There are some there.

WARNING For Chrysler 200 Owners

First off, the part was right and fit well, no complaints there. I was honestly impressed by the quality of the part itself. There's a fix that you might find where instead of taking apart the entire dashboard of your Chrysler 200, you just cut the pipes on the old one and the new one and use heater hose to connect them. I thought it was a clever shortcut, but after months I still have not been able to get a good seal and I can't tell you how much antifreeze has dumped out of the heater core into my carpet. In the video you can even see a drop of antifreeze leak out. If you buy this part make sure that you do the full replacement of the heater core. If someone online has a 'shortcut fix' for this, it isn't worth it.

Heat on passenger side

Working just fine. Was the fix for no heat on passenger side 2010 journey. Had to cut hoses so voids the warranty but didn't have to take the dash out. Also much cheaper than auto parts store. Cut old one open and can see why no heat on that side.

Fits great works good for now.

I like the price the best put in a 2009 dodger journey that seems to destroy heater cores. This will be the 7th one in 10 years very bad design from dodge. They plug up and only give you heat on the driver side or leak around the rings that the pipes hook up to the actual heater core. Watch the video on Utube and cut the pipes and use some heater hoses and clamps. You can get this done that way in about an hour.

Amazon rocks 🤘🏽

Liked the part. It fixed perfect. Never had amazon send me the wrong part . Keep up the good work. That part went in my 12 Dodge Avenger 👍🏽

Ya I did the cut the lines and splice

All went well with the splice since I was prepared. Way better than trying to remove this in one piece. What a stupid set up by dodge. Every place I called wanted $600 plus just to swap out the heater core

What a difference!!!!

Excellent fit. Watched a few YouTube videos for the install. Two hours of work, and saved over $1400. and it was super easy. Great product. Had no heat on passenger side, now its HOT heat on all vents.

Works perfect

Works just like oem now my friend has heat again. Old one was clogged horrible. 2012 Dodge journey. $1800 dealership charge 8 hour job. Did the job in less than 4 and for roughly $85.

Looks like OEM

Perfect, good price. Install looked difficult if tearing dash apart to install through firewall. On internet found shortcut and cut tubes and connect with hoses. Works great. I now have heat in car.

Great part!

This cost me probably 1/4 of what the dealership wanted to charge me for this part! Exact part that I needed. Shipped quickly too! The part itself is very easy to install but the only downside is where the car manufacturers put it. It’s hard to get to but once you do, installation is a breeze.

Full Reviews