Features:

  • 1 piece 12 by 48 inches
  • Color: dark black
  • Self-adhesive, peel and stick
  • Stretchable with heat and water resistant
  • Easily cleansed with water and easy to remove without residual
Good for the money, hard to apply if its your first time

I was surprised that it actually has a sticky side, first time applying this was a pain in the but. Product us good stretches real nice I apply using water and with out water worjs best with out, stick it in one side and stretch it all around the tail light. I bought two thinking it will be enough for both my cars, it was just enough for my Kia Forte. Let see how it holds up in the next couple of weeks.

tinting ain't easy oh yes it is

very easy to work with went on smooth looks good. hope it holds up to fading but cheap enough to buy more

Very good item, easy to work with!!!!

This item is very easy to install, you have to be very careful while installing it because you need a soapy water, hair dryer and that is it, almost forget patience!!!! It deserves five ⭐⭐⭐⭐⭐

2004 Nissan Pathfinder Tail Light Tinting

Outstanding vinyl wrap. Needed to wrap my rear turn signals because I have LED amber turn signals and was too bright with a clear lens. A heat gun is recommended to go over curves in the tail light.

Not a beginner product - looks great

But a couple rolls. Heat gun necessary - finished product looks great

Good stuff but lots of patience required!

Not sure why everyone is having a hard time, the film worked great on my Miata tail lights and they're round not flat. I wrapped over the orange turn signal of the tail light and looks great! I didn't need soap water or squeegee, just lot's and lot's of patience and steady hand. Lay the film down from the center of the light and slowly push bubbles away from the center with your fingers. Maybe needs another layer to get a deeper red but the orange is gone so I'm very satisfied.

This is great stuff!

Some of the reviews say that's it not sticky. That's because they don't know what they are doing. This stuff is very sticky, after removing BOTH protective films. I tinted my fog lights which turned out pretty well. I'm not experienced with vinyals and wraps, so the job wasn't done perfect, but it still looks good.

Auto headlight protection

Cut pieces to size and it stuck onto my RV headlights so that they will not be degraded by the sun. Nice.

Only vinyl I’ll ever buy.

Only vinyl I’ll ever buy. Super good quality. I’ve tinted 4 cars with this and it’s super easy to work with and it leave you with a glossy finish.

Great way to replace 3rd brake light

We had a hard time finding the replacement lens cover for our Sprinter motorhome 3rd brake light, so we used the self-adhesive film to create one. It stuck perfectly and has held up well in wind, rain and cold weather.

Full Reviews