Features:

  • 【Check Centered Stud】TV wall bracket fits for most of 26-55" TVs up to 60 LBS, with max VESA of 400 x 400mm/mounting holes spacing. Images on left side will help you see if this TV bracket perfectly fits your TV in the aspects: VESA, studs position and possible blocked input.
  • 【Flexible】Full motion TV wall mount makes viewing more comfortable: tilts TV up 5° and down 15° to reduce glare, swivels TV left or right according to your seats position. Pull out to 19.3” and retract back to 3”, making your TV alive to move.
  • 【Easy installation 】TV mount with decent instruction and all included hardware in pre-labeled bags. +/-3° post-installation adjustment allows perfect TV leveling. Comes with cable ties and bubble level as gifts. Concrete anchors will be sent per request. All our TV bracket are NOT for dry wall alone installation!
  • 【Safety & Stability】Technology of robot welding makes whole TV mounting bracket unit sturdy and safe.
  • 【100% Purchase Guarantee】Patent No.: 29/588,044. US based customer support answers your pre-purchase and installation questions. Our mount is 10-year warranted!
The TV mount has tons of funactionality for the price!

I wanted my 50 inch insignia smart 4K tv with Ruko in the corner of my room. I didn’t use a stud finder, I found the stud by looking for the electrical outlet, I measured 16 inches for the center of the stud that the electrical outlet box is attached too and then determined the center of that stud. My wife and I already determined, prior to even receiving, the mount what the height was going to be so I did a small pencil mark for the height and the center of the stud. I have an impact drill and a hammer drill so pre-drilling with a wood bit the Lag bolts were not difficult. If you don’t have an impact drill, drill the pilot holes and then use a ratchet. In my opinion the Lag bolts are more heavy duty then I needed because my tv is no where close to 60#s. The TV already had screws for a tv mount so I did not have to use any of the additional hardware that was included. It’s my understanding that the TVS will actually indicate the type of hardware it needs to be mounted so just make sure you have lots of light cause it black written on a black TV. If your TV is over 40 pounds, you might want to secure the mount to two studs but it’s not necessary if you drill your pilot hole directly in the center of the stud. I think it was easy to install, it was a great price and once I get my spare room setup I’m going to buy another one! I’m very happy with my purchase. FYI studs are either 12,16,or 24 inches apart and you measure a stud to another from the center to center. Hope that helps

Amazing Value

First of all, I am an A/V technician, so I deal with all sorts of mounts and scenarios on a regular basis. For some of the lighter tv's out there now this mount is perfect. I put a 55" 6 series Samsung 4k tv on it. This maxed it out on the 400 x 400 mounting pattern so it fit tight but that is a plus to me, there's no way for the tv brackets to slide on the mount while I am repositioning the tv, although it does have two lock screws on the bottom of the brackets. It's a single mount design so installation is a breeze, though you do have less options for placement so make sure this will work for you. The tv parks pretty close to center so you can get a good idea of where it will be with minimal measuring(you can also park it with right or left orientation, so you can change which direction the offset is) It has tilt and side to side level adjustment, so it is basically impossible to not be able to level your tv even if the mount isn't level on the wall(although I don't suggest this) Compared to mounts that I usually deal with(sanus, omnimount, etc) the features are essentially identical. The build quality of the tv brackets are heavier duty in the more(much more) expensive brands, but if you stay within the weight limitations why do you need them to be? The included hardware exceeds most mounts I've dealt with, which really surprised me. Sometimes you need a goofy spacer setup if the perfect length bolts are not included(looking at you samsung) and this mount includes various sized spacers and washers. For a tv that comes in at right about half of the recommended weight limit I have 100% faith in this product and would choose it every time over any other brand, especially with how ridiculously cheap it is. You can barely find basic tilt mounts for this price, and it has buttery smooth full motion movement with my 55" tv

Don't bother with a more expensive option. This is nearly perfect!

What a steal. Here are my pros and cons for the Mountin Dream MD2377: Pros: - Heavy Duty. Even better build quality than many more expensive options available at big box stores. I have total confidence in having my TV mounted to this unit. - So simple to install. If you've got a wall stud to work with it takes a whole 10 minutes to install. You'll need a friend to hold it up for a moment though. - Great microadjustment options to center, or off-center the screen, and to adjust the level. - Does not interfere with my tv's inputs. I've got a 55" Hisense 55h6b. The inputs are far off to the side, and below, the mounting bracket. - Comes with an HDMI cable, which is great since I accidentally broke my existing cable about 5 minutes prior to mounting this! - Comes with tons of screws and bumpers for mounting every possible brand/model of television. Now I've got a whole collection of extra screws in my spare drawer, no extra charge! Cons: - The articulating joints are extremely tight. Like... it takes some force to push and pull my tv away from the wall. So much so that I worry sometimes I could possibly hurt the TV. Is I only move the tv from the wall on a rare occassion this is not a huge issue. The tv can be angled from side to side quite a bit without moving it from the wall. Note: - Not that this is really a con per say, but do not trust that it will be level out of the box. The mounting plate on my mount was drilled into the wall perfectly vertically level, however the TV was crooked when mounted. There's 4 levelling screws though that are very easy to adjust and get the TV perfectly level. - The up and down angle cannot be adjusted on the fly like the side to side swivel can. You have to do so with tools. Not a big deal.

Sturdy single stud mount

This mount is great because it attaches to a single stud instead of two. Exactly what was needed in my situation. Comes with perfect instructions and heavy duty stud bolts. You will need an electric drill and to drill a pilot hole first. But you should do that for any mount you get. My Samsung 50” is a little older so quite heavy and near the max of the suggested range. This thing feels like it’s concreted into the wall and doesn’t budge or wiggle at all. No doubts that’s its secure and definitely isn’t going to fall. The only thing to note - because of the design of the extending arm, it will not be dead center when extended. Great overall mount. Highly recommended!

You will want this!

Mounting Dream MD2377 TV Wall Mount Bracket works great holding my 50" LG 4k tv. The serious part is locating the stud. That figured out..I (actually my son) used the 3 location holes in the middle of the mount. The bolts supplies are huge and almost overkill since TV's are getting lighter and bigger. I swear this could probably hold a plasma! There are 4 other holes on the top and bottom of the mount where one could use Molly-bolts, but I don't recommend using molly-bolts unless it would be for back up.. It was handy of them to include a level with a magnet on it. It helped tremendously with the install, since I don't own a level. And the price, I feel like I stole it compared to all the Big Box stores.

Absolutely perfect...

Not really a review writer unless it’s warranted...this is! I have purchased numerous wall mounts and this one is by far the easiest, most function able, sturdiest and so on. No need for a 16” or 24” stud spacing mount. This works for both and on concrete. Mounted a 55” TCL, 32” Samsung and 65” Vizo...all with zero worries about the capabilities of this mount(s). This is the review that everyone should use...

PERFECT FOR MY $700 LCD FLAT SCREEN T.V!

For Large Flat Screen TV's Durable brackets are very hard to find. I was skeptical at first but reviews from "Verified Purchaser's" are Key when using Amazon in my opinion. This Product comes with all the necessary components to fit the TV sizes as described and comes assembled for fast wall mounting. As a bonus it includes a HQ HDMI Cable for your TV. There are precise directions that are EASY to follow and very durable screws and anchors for mounting. I STRONGLY SUGGEST you spend $10 on a Stub finder! I can only imagine if you have a TV larger than a 40inch the weight will be heavy. The bracket itself is by no means cheap! Its Solid! Feels like Steel and the Swing arm is strong! I HIGHLY Recommend this product especially if you value your TV or if its expensive! I had questions so I contacted the seller and was met with FAST and Very Friendly A+++ Customer Service! This is an Awesome Buy from Amazon! Worth Every Penny

Simply Solid!

I am usually very picky when it comes to picking a wall mount. It could be from the fact that it's job is to hold $1000 worth of product 5ft off the ground. Never the less I purchased one of these for a cheap tv to mount in my daughters room. I installed it and was actually taken back by the quality of this less that $30 mount. I waited about a month to see how well it held up to a 2 year old pulling on cables.(I need to move them up I know) and it is still holding strong. So I've since purchased 2 more. Both holding 65" 4K tvs. These are amazing products and I'll be purchasing 3 more in a month for my man cave!

Totally YES! A bargain!

OMG. What a great wall mount. I am using it for a 40 inch television, but as I was installing it I checked to see if it would fit my much smaller 21 inch monitor - it does. I will be purchasing a second bracket. Back to the 40 inch television - I wanted something I could swing out to view from the kitchen. This is great!!! It tilts in both directions laterally, I have not tried it vertically. And I love the swing out feature! Mount it in a stud. Seriously. Anything else and it will simply fall out, ruining the wall and your television. Think about what your television weighs? As you move the television away from the wall, the strength needed to hold the thing up increases. A stud. You need a stud. Also, I ran the wires behind the wall and that worked out just fine. It comes with little velcro straps so you can keep the wires close to the bracket without them getting in the way of the motion of the bracket. It doesn't sit flush against the wall because of that swing out feature but it sits close enough to the wall to not be visually bothersome or that you would notice it.

works great and easy to install

works great and easy to install. Fit my tv great and allows me to set it in a corner.

Full Reviews