Features:

  • Rectangular metal magnetic plates to attach device onto magnet mounts.
  • Great to use with smartphones and tablets magnet mounts.
  • The magnetic plate mount easily sticks to the back of devices for easy mounting
  • Very easy to attach without a hassle.
  • Works with magnet mounts designed to hold devices with the metal plate,
Very Strong hold

Works perfectly behind my Otterbox case and I did NOT have to stick it to my phone. Do NOT stick this on your phone if you don't have to because I've seen countless reviews showing how hard it is to get off without some form of damage. Also, do not put the magnetic side (I know both sides are magnetic) but the one with no sticky pad.... just place it inside your case with the pad side touching the phone... metal side..touching your case. The strength is great for the larger rectangular ones and I've not tried the smaller ones, but assume they're good too for smaller phones.

Excellent for magnetic mounting for 2 devices

Purchased to replace an aging volfon case with 1" diameter circular medal mount and ring holder combo for a S7 Samsung. With a spigen case and these wiz gear metal tiles for magnetic car mounting support. The volfon case with its key ring is nice for holding but terrible for magnetic mounts. The 1st image is the spigen on top and volfen on bottom. On the right is the 4 wizgear metal disks: 2 rectangle & 2 circular. 2nd image shows the best location i placed the wizgear metal between the tpu shell and rubber layer without adhering it to the spigen case. I layered the circular slightly over the rectangular one and didnt notice any bowing after putting the phone in. Note* I initially, attempted 2 rectangular ones horizontally however after setting the phone in. noticed an air gap between the tpu case and rubber which caused a clicking sound much like a milk cap. Overview this product is self explanitory it comes with 4 self adhering disks. You may or may not have to use the adhering.. i did not. Set it up between the tpu/rubber layer and it works fine. When driving, the mounts hold up to bumps, taps, without falling off.

Strong bond!

These magnetize super well on my car mount. I was actually surprised at how strong they stuck, compared to my old phone case which had a built-in plate on the back. I used 2 rectangle plates positioned horizontally so there is more magnetic area to use, and adhered them to the inside of my iPhone 8 Plus case, not to my phone. The back of my phone is glass, so it remains to be seen if there will be any scratching from them. If so, I will stick them to the phone itself, but they are smooth and very low-profile, so I don’t foresee any issues. Would recommend to anyone, great price, too!

Nice and thin. Very powerful magnetic plates

These plates work really well with cell phones and cell phone cases. They don't stick out but are very strongly magnetic and hold the phone onto the dashboard magnetic phone holders. Update - after using them for a few days. These magnetic holders and their plates are strong. In my case, way too strong. The problem was that when I tried to take the phone off the holders they wouldn't separate and the entire magnetic holder pulled out of the air vent and remained stuck to the back of the phone. Removing it by hand was pretty tough. These things are powerful!! Solution. I hacksawed one of the rectangular plates vertically, into a piece about 1/3 the size of the original, filed the rough edges smooth where the hacksaw had cut the thing, and then used contact cement on the phone and the back of the smaller piece of plate to attach the plate to the phone. Worked perfectly. Cutting the plate in this way reduced the magnetic attraction to the point where I could now remove the phone properly, but the attraction was still strong enough to hold the phone in place.

best phones mounting system I've found

I bought this system a few years back because i didn't have a place on my dash to mount my cell phone other than the vents. WizGear had systems for all types of mounting situations. It worked perfectly. Never had to worry about the magnets losing their hold. It held just as well whether the magnet for the phone was on the phone or outside on the protective case. In a move i lost my extra magnets so when i lost my phone i could no longer mount my phone on the dash. I was happy to see the company was still out there selling their products. I've been really pleased with this product. Just put it against the holder and it stays in place no matter how rough the roads.

Just as described. Works well with different mounting systems ...

Just as described. Works well with different mounting systems other that wizgear. Sticks well to the inside of my case and holds well on magnet car mount.

Very pleased.

I have installed the round one on an iPhone XS with an otter box case and am using a Ram mag mount. Very pleased with the plate. I had been using the rectangle plate, but wanted to use the smaller one for astetic purposes only. The rectangle one does provide more mounting force but not necessary. I have now used the round one on an iPhone XS Max with a case. It provides plenty of mounting force. Have no concerns about phone becomning dislodged from the mount. The adhesive is very tough. Be sure of placement because once mounted you will not get it off without ruining it. The plates are very thin so do not add bulk to the phone.

Works great super thin

These are great. I lost the original magnet I got with the magnetic Mount I bought in a store so I bought these as a replacement because I had the tiny little rectangle on my giant Note 8. I also bought these because they are super slim. I bought a vinyl skin from decalgirl online and I use a clear case on my phone but I didn't want to put the magnet on top of my skin or case and ruin the aesthetic, so I bought the super slim magnets and I put it underneath the skin and it looks perfect. It's an almost invisible and doesn't affect the skin at all. I put this underneath my clear case as well that is pretty slim and it still works just fine with my magnetic Mount and grips even better now that I use the larger magnet.

Very nice product.

Product looks great but have yet to use it. I purchased an Iphone 8 plus and really enjoy the wireless charging. If I use the plates on my Iphone case then I will need to remove the case every time I want to charge my phone wirelessly. Still debating if I want to use them. I do prefer the magnetic phone mounts because they are so easy to place and remove. The color does match very well with my gold case.

Perfect replacements for my Anker magnetic car mount when my ...

Perfect replacements for my Anker magnetic car mount when my phone case broke and I needed new metal plates for my new phone case. I just needed one rectangular plate, but the 4 pack worked out great- I gave one to my boyfriend so he can use my mount when he's driving my car (we travel/take road trips a lot), and I wound up using the smaller rounds for my old ipod shuffle, which isn't really necessary, but wound up being really convenient with the extra plates this pack provides. Haven't had any issues with the mounts not holding to the magnet while the car is in motion (and I live in a mountainous area)

Full Reviews