Features:

  • Rockville RXM-S30 2400 Watt 4 Channel Proton Micro Marine Car Amplifier.
  • CEA Compliant Power Ratings: 400 Watts (4 x 90 Watts) at 4 ohms and 1% THD+N. 600 Watts (4 x 150 Watts) at 2 ohms < 1% THD. 600 Watts (2 x 300 Watts) bridged @ 4 Ohms < 1% THD.
  • RMS Power Ratings: 800 Watts (4 x 200 Watts RMS) @ 4 ohms. 1200 Watts (4 x 300 Watts RMS) @ 2 ohms. 1200 Watts (2 x 600 Watts RMS) @ 4 ohm Bridged.
  • Peak Power: 2400 Watts (2 x 1200 @ 2 ohms or 1 x 2400 @ 4 Ohms). Marine amplifier with conformal coated PCB board. High-Speed MOSFET Power Supply. Studio-Grade Bipolar Output Stage Transistors.
  • Double Sided Surface Mount (SMD) PCB Design. Selectable +6dB/+12dB Bass Equalizer @ 45hz. Channel Separation: 50 dB. Current drawn @ MAX RMS output: 27A @ 4ohm, 40A @ 2ohm.
  • Efficiency @ MAX RMS output: 65% @ 4ohm, 60% @ 2ohm. 2-Ohm Stable Stereo. 4-Ohm Mono Bridgeable. 3 Channel Mixed-Mono Capable. Input sensitivity: 20mV-6V. Mute and Delay Soft Start System.
  • Full IC-Controlled Protection Circuitry. 2 CH / 4 CH Input Mode Switch. RCA Preamp Line Output. 8 Volt Preamp Circuitry. Status Mode LED Indicator. 4 Gauge Lucite Encapsulated Power/Ground Terminals.
  • 12 Gauge Lucite Encapsulated Speaker Terminals. THD+A: 0.01%. Frequency Response: 15Hz - 20KHz. Continuously Fully Adjustable 12dB / Octave Crossover with Differential Circuitry.
  • Continuously Fully Adjustable High Pass Crossover: 50HZ – 250HZ. CH1 & CH2 High Pass 50Hz - 250Hz. CH3 & CH4 Low Pass 50Hz - 250Hz. CH3 & CH4 High Pass 50Hz - 250Hz.
  • Full Adjustable Crossover Controls: low pass, high pass, and full pass. Sensitivity: 100dB @ 1w / 1m. S/N Ratio: >90dB. Damping Factor: > 200 @ 100Hz. 2 x 30A Fuses. 7 LBS. Dimensions: (W x H x L) 6.7" x 1.98" x 12.28".
Great sound, Priced right.

Quality built unit. Has great sound, Grate value. Rugged build. Mounted in my Mahindra Roxor UTV under the dash on the passenger side. Plenty of Audio power for outside listening.

This thing is awesome, tons of power

This thing is awesome, tons of power. The only deficiency I can find is in the very deep base tones. For the money this thing can't be beat. Great for a boat. If someone rips it off I'm not gonna cry. I have one running my towers and a 10 inch sub, and I have another running 4 6 inch miss with 6 tweets on a cross over. Sounds awesome

Quality amp.

Easy to install and sounds great

Great amp/Great price

Arrived on time, look of finish on amp is nice. Installed in my side by side running 4 rockville 8inch tower speakers and pushes them extremely well. Very happy with this amp this is the 2nd rockville amp i have used the other is in my boat. If you are looking for a great amp at a great price you will not be disappointed.

Good for the money

Easy to wire and mount in my boat. Had it cut out on me a few times when it overheated I suppose. Recently rewired the tower speakers and haven’t had any issues since.

Really a good purchase

This was installed below the drivers seat, so far the device has worked flawlessly, it brought the sound of my car to a completely new level, and is now working great. Also thanks for the good customer service and kindness of your customer representatives!

Very Happy with this Amp

Very Happy with this amp. I was not happy with the stock sound quality in my boat ( Monterey 220 EX Deckboat) so I decided to to venture into an audio project with the goal to achieve great audio at an affordable price. For my boat upgrade I used the following; Head Unit - Used the old head unit ( Kenwood KTS-MP400MR) with 3 RCA pre-outs ( front, rear, and sub woofer, this is key since you use the pre-outs to connect the to the amp) Amp - Rockville Rxm-s30 micro marine amp providing 4 channels of 4x 150 watts CEA rated, and 4 x 300 watts RMS Base - Rockville RTB10A 10 inch 500W Powered Base Tube Subwoofer ( this provided me good base without cutting into the boat for large base speakers) Front and Rear Speakers - Polk 6.5 inch Coax Ultra Marine Speaker MM651UM Peak 200 watts per speaker ( to replace the stock speakers ) Speaker Wire - Hitron SPW 12-50 12 Gauge Speaker Wire to replace the old smaller wire BlueTooth - Added the JL Audio MBT-RX Bluetooth receiver to update my older head unit to accept iphone and Pandora type audio signals. Power Lead - Hitron PW420R 4 Gauge Power Lead Red Ground Lead - Hitron 4 Gauge Ground Cable Brown Main Power and Ground Distribution block ( one each ) Scoshe e2 EDB (1 - 4 gauge in, 4- 8 gauge out ) Power and Ground Leads to amp from distribution blocks - 8 gauge Kicker PWG8200-1 ( sold by the foot ) RCA Stereo Interconnects from Radio to Amp and Bass Tube - Stinger Sl126 After I was done installing all of this myself, it was time for the moment of truth...Connected the battery cables and fired it all up...Results... it rocked! I feel I got professional sound installed in my boat at a fraction of the cost that would normally be considered with expensive amps, speakers and subs. I am getting very clean highs, and very good lows. It basically sounds like I took it to the audio shop and paid for high end professional installation and top shelf gear. Now, we just need to see how long it lasts... I had it out only once to Lake Mead for a week in 100 degree weather and it all worked like a champ. Only time will tell how it will handle the test of time.. Note: if you are doing a boat installation, its important that you wire up the cables correctly so that you get clean sound while the boat is running. The head unit and amp power should be connected to the same common power source depending on whether your boat has a dual battery switch or single battery. The Rockville Amp and the Powered Bass tube are producing great sound at a great price!

Great Amp!

Great amp for my boat, really adds depth to music!

Buen producto

Ayudo mucho a mi equipo marino

BADTOTHEBONE

BADASS FOR THE PRICE....

Full Reviews