Features:

  • Brand : TMH with 1 years Premium TMH warranty ( Free Replacement )
  • ( Pack of 2 ) Red Light & Red Lens 2 Functions : Tail Light & Brake Light with 10 pcs Super Bright Piranha LED on each light
  • High Quality Material with Ultrasonic Welding Process : Waterproof + Shock proof + Dust proof
  • Work on 12v DC : 3 wires with 2 steps Brightness , Can Modify for Signal Light , Flash Light , Emergency Light ( Flasher relay or Controler not included )
  • Surface Mount : Easy to install and wiring in minute , 4 screw included
Very good LED taillight for trailers

Lights are just as advertised, good difference between running and brake lights, very bright. Flat across the back making an easy installation, just cut a hole for the wires. Doesn't come with wiring instructions, but the Amazon site had it listed in the specs. (black is ground). Mounted to my cattle trailer, very pleased with the outcome. Will purchase again if I need to replace tail lights on any of my other trailers.

Easy to install, very bright

Like thebflush mounted screw holes. Much easier to install than the ones w the gourmet mount. Wiring takes a look a little extra time since I replaced 2 wire lights that were self grounded so had to mount the ground wire at the light mount. But that was expected.

I LOVE IT.

clear marking lights and turn signals, I LOVE IT. TMH ( Pack of 2 ) 6" 10 LED Surface Mount Oval Amber Turn Signal Side Marker Tail LED Light for Truck Trailer Trail Bus 12V DC

Best bang for the buck!!!

Built this tilt deck out into a nice cargo trailer. I needed alot of affordable lights, and I found some. These were good in the rain the moment I tested them. The tail lights are a little tricky with the ground and running lights but just connect them directly to your battery and you'll figure out which is which.

Cables are not marine specs, but work fine

Tooknme time to figuer out what colors did what, cables not a marine specs, more like vehicles wiring but they work great, using them for a jetski trailer and so far no problems yet...

Nice and bright

These are really bright. The potting is great, the wires are thick, and they went in great. I didnt use any of the marker lights as they are not overly bright and I didnt need them.

Great lights!

I bought these lights as an add-on set of reverse lights for a small concession trailer. The lights have a 4-point screw-mount setup and will need about a 3/4" hole (basically an oval will do, parallel to the long axis of the unit) for the wiring to run through as the protective epoxy at the wire exit protrudes out too far for a true flush mount. This light has the standard dual-level output of a parking/taillight setup with a 3-wire connection. I'm only going to use the black (-) and white (+) wires for the higher output (think brake lights/blinkers). The black (-) with the red (+) will give you the lower level (parking) light feature.

Good LED lights

Bought these to replace the lights on my travel trailer. I had issues with running lights and brake lights before and this resolved my issues. They were easy to install and work well for 4pin wiring setup with seperate brake/turn and running wiring.

Super Bright and easily seen.

Excellent product. I bought to replace my old dim crapy tail lights. These come with a mounting flange on them which in new institutions is great. I was replacing an existing fixture. To make that work I modified them by cutting off that flange and filing them down to fit my rubber grommet. You can see in the picture I gave provided. They are super bright and should last. I love that they aren’t red, and only turn red when activated. I would buy again for sure. I definitely recommend this product.

Just What I Needed

These lights worked out perfectly for what I wanted to achieve with my utility trailer. I wanted flush mount LED lights with clear lenses and these were perfect. They were easy to install and I’m saying this as a rookie. I’ve never installed or wired lights on anything before. I simply got some advice from some friends that did know what they were doing and incorporated some YouTube videos into the mix and viola! Just in case some are still confused regarding the wiring, here’s the breakdown: Black = Ground White = Brake/Signal (BRIGHT) Red = Parking Light (DIM) It’s only been a couple of days since I installed them, so I can’t speak for the longevity of these lights yet. It did rain twice and so far so good. If any of that changes, I will update this review. The lights are very bright. As you can see by the attached picture, I installed 8 of these lights on the rear of my trailer. At night, they’re almost blinding if your directly behind my trailer. As it stands now, I highly recommend these lights.

Full Reviews