• 6-in-1 Z-Wave Plus MultiSensor: motion, humidity, temperature, light lux, UV, vibration sensor.
  • Up to 2 year battery life with 2 batteries or power via USB. 1 x CR123A included in the box.
  • Super-small at 1.65 inches. Can be installed in corner, in-wall, on shelf or recessed in ceiling with Recessor accessory.
  • Works with certified Z-Wave gateways and tested with Fibaro, HomeSeer, Indigo 7, openHAB, SmartThings, and Vera.
  • Z-Wave Plus certified. Certification number: ZC10-15070011

I went through an upgrade from my exterior X10 motion sensing lights to ZWave. I was able to power all the sensors with USB, so no more changing batteries every year. I mounted each sensor under the eves away from direct moisture, and they have thus far performed well. Because they are USB connected, the low temperatures in New England are not an issue. No more X10 lights stuck on.

Added with ease to my z-wave network (using Aeotec USB z-wave stick and HomeSeer for controller software). I use it in my bathroom for motion-based control of the lights and it works well. The long battery life of the A123 cells is a plus over the older AAA-powered model.

It's not a bad sensor. It's better when using the USB power instead of batteries. Works well with smartthings when using a custom device handler found on the community website.

Multisensor works great, easy to setup in smartthings and webcore. Have been using it plugged in for the past month and very happy.

I put 2 batteries in it because I am using it to watch a second home in Florida where I want to make sure the humidity is not too high as well as watch for motion. So far still shows 100 percent battery and has been working great for over a month. Temp and humidity pretty much agree with what my smart thermostat says.

For me it’s great

Kind of bulky, but all in all a great multisensor.

Ease of installation and adjustment.