• Tire: 20x10.00-8 Tubeless Turf Saver Tread - pneumatic 4 Ply rating - check your existing tire sidewall for size and hub size to ensure proper replacement fit
  • Wheel: solid yellow Steel, 3.5" offset hub, 3/4" Bore with 3/16" keyway
  • Load capacity/speed: 1, 200 lbs./ not for highway speeds
  • Use: replacement for rear mower tires 20x10.00-8 (check existing sidewall size for proper replacement fit)
  • Low hassle, low cost solution to repair or replace your mower tires

Purchased two of these tires to replace my old and always flat tires on my John Deere L118. They were delivered fast and only took about fifteen minutes a tire to replace. I watched a you tube video, got out my truck jack, used a heat gun to slide the cap off, a screwdriver to pop off the fastener and that was it. I reused the old cap, washers and fastener since these don’t come with these tires. As others have said, make sure to slide the key in the groove on the axel or your mower will run but not move. Would recommend for anyone with a John Deere L118 mower.

Tire very good fast shipping fits perfect 5 minute change out cheaper than tire by itself at store her rim and all would recommend new washers and covers and key in a bundle but used old ones worked great will buy again

I purchased these tires for my LA135 John Deere. They fit perfectly. I would recommend purchasing a new dust cap since you probably wont be able to get it back on. The clip should be OK to use again. I had one tire that took some WD40 to loosen it enough to pull off but that didn't have anything to do wit the tires. I would purchase again.

I searched everywhere for a replacement rear wheel for my 42" Craftsman mower...to no avail. I had two inner tubes fail and wanted a plug and play wheel assembly. I took a chance on this wheel and it fits perfectly. My mower is 20 years old, has 3/4" axle and this matched up right down to the keyway. I ordered the second one today!!

These were an exact replacement for my John Deere L118 mower. Original tires were 13 years old. Fit was perfect. Tires look to be good quality.

Came right on time. Looks like a good well made wheel and tire, Fit right on with no problems.

Kind of a no-brainer! There's no point screwing with tubes for your old cracked sidewall tires or having new ones mounted on your old rims...these are exact replacement for your John Deere (others?) and slip right on with ease! They're even pre-inflated for you! If you're putting these on in cooler weather, use a hair dryer to soften up the rubber axle cover, get it warm and it will become very pliable and slip on and off with ease.

My riding mower back tire got a large hole in it. I replaced both of my back tires for the price of replacing one at the tire dealership. Tires came on the correct size rims and mounted- saving me time and the hassle of mounting. I have about 5 hours on them now and it was a great deal for me.

These tire/wheel combinations are a perfect fit for my 2011 John Deere X300 axles. Note, these tires and the OEM's are both marked 20x10x8.00 but the new Marastars are about 2" larger in diameter, see photo and the OEM's aren't worn that much! This is not a problem if you replace both rear tires, might want to adjust the cutter deck height. Replacing just one rear tire could be interesting if you're particular about the appearance of your lawn! I gave 4 stars for durability because I won't know for a few years, no cause for alarm so far.

Don't hesitate to purchase to these, original John Deere Rims and Tires. Swamped these out in 10-15 minutes. I had purchased tires only from another online seller , wasn't a good idea....Took 4 hours just to get a tire off and replace new and then realize, It wouldn't take air, as they are shipped crushed ...Had to return and order "the real deal and save 12 Hours over 2 days.