• One Slide hammer assemble 2.5 jaws.For removal of Pilot Bushes Bearings etc. form blind housings.
  • Thread:M10×1.5p, M10×1.5p,M8×1.25p, M10×1.5p M6×1.0p.
  • Screw adaptors M10x1.5p, M10x1.5p/M8x1.25p, M10x1.5p/M6x1.0p
  • Collets sizes:8-11mm 12-17mm 13-23mm 18-23mm 24-29mm 30-34mm 34-38mm 39-43mm 44-48mm 49-53mm 54-58mm
  • 1 x Counter stay puller

Works great. There is a larger selection of sizes than I expected.

Never realized these were even made or I needed this tool. It works wonders pulling bearings.

A most have if you working on transmission. Never realized how much easier it is to pull a blind bearing with the correct tool. Been rebuilding manual trans for a while and this is a must have for bearing pushed into the case. Most have the tool completely centered for it to work. Took under 2 minutes to pull all the bearing out the case. Slide hammer is a little on the small side but makes it usable in small access areas. If you have another slide it screws right in, so no worries

Built heavier than I expected worked very well

I had a very stubborn bind bearing and this set removed it with ease. Highly recommend it if you work on small engines.

This is an incredible set for the price that I paid. Use them to get out some bearings from a hub assembly. It was very difficult to pull the bearings had to heat up the hubs and then freeze the bearing race to pull them out the tools never failed and ultimately successfully pulled them out.

I bought this product working on a tractor front end . Tool worked beautifully and the shipping and condition of tool was spot on . Will definitely buy other products from these people .

Worked like its supposed to.

This is an awesome tool and must have in any garage. Worked perfect, thanks

Worked just like it should.