Features:

  • ☛ Easy to install, No drilling required, Non-Locking, smooth door operation, and anti-corrosion finish
  • ☛ Non-Locking type for your gas tank cap
  • ☛ Smooth Door Operation, Meets All Chrysler Corrosion Standards. Black Thermoplastic with UV Treated for Durable and Long Lasting
  • ☛ Custom Designed Give Your Vehicle a Sporty Look
  • ☛ Fitment:2007-2018 Jeep Wrangler JK JKU Sport Rubicon Sahara Unlimited (2 door & 4 door)
JL gas cap

Fits and looks gook

Nice fit

Installed in 5 minutes. Color matches nicely to the trim on Jeep

satisfied

perfect fit. instructions? meh. but really unnecessary. looks great. works great. very happy

Looks great

Finally an affordable cap cover for the 2018 JL. Only took me few minutes to install. Tension clips needed to pushed out a little so they locked into sheet metal securely.

Fits and looks great; with installation tips

I couldn't figure out their wordless, poorly diagrammed instructions, but installation was fairly straightforward and took me less than 15 minutes once I watched the 5-minute YouTube video showing how to install a Mopar Jeep Fuel Filler Door. It shows that you have to remove the left taillight assembly and pop two plastic tabs to remove the old plastic piece. The guy on the video I watched said the hardest part for him was removing the old rubber gasket and installing the new rubber gasket. I found this easier to do than he did if I pushed the old gasket off the filler neck from behind using the same long screwdriver I used to pop the two plastic tabs to remove the old (non-) cover, then installed the new rubber gasket in the hole on the new cover with my hands while off the Jeep, then gently worked the gasket around and over the filler neck with a screwdriver until it was past the filler neck rim, and then pushed the filler neck from behind and the new cover towards each other until the new cover was pulled near the car body. Also it helps to loosen the 4mm hex screws on the cover (take care not to lose two nuts, one each behind the top and bottom screws) and be sure to get the tiny spike behind the cover pushed through the hole in the body to the left of the filler neck before attaching the new cover and tightening the 4mm hex screws. BTW if you want to add a locking gas cap, the Omix ADA 17726.17 available on amazon at this writing fits well under this cover. The less expensive Stant 10504 may fit too, but the Omix had slightly better ratings on average and works well.

nice

imprint is grey so doesn't show as well as I would like but still easy to install and looks great

Cool and easy add on for the Jeep Wrangler

Easy to install, took me 20 mins, looks great and nice finish, shipped fast and comes with detail instructions with pictures

Full Reviews