Features:

  • Tank Support Crossmember Replace for the Crossmember Located Forward of the Rear Axle that Supports the Rear End of the Gas Tank.
  • No Need to Remove the Truck Bed, Just Remove the Fuel Tank, the Old Shock and Cut Away the Remaining Crossmember.
  • Two Outer end Plates and Right Side Inside Mount Plate are Sent Loose for Ease Of installation.
  • Fit for 1999-2006 Chevrolet Silverado or GMC Sierra 2500 and 2500HD
  • Function：Pre-welded on the Cross Tube are the Left Side Inside Mount Plate, the Right Side Upper Shock Mount, the Fuel Tank Strap Hanger Bracket, and the Fuel Tank Support Mount Bracket with New Bolt Included
Perfect

I ended up not using this- but the welds and fit were perfect. Came coated and rust free with easy instructions. Thicker internal diameter, brackets were perfect- wish I just put it on instead of sending it back- very good quality.

Much easier to install than to fabricate your own

Fit perfectly into the frame, the only issue was that the exhaust hanger bracket had to be transferred from either an old piece or a new one fabricated. However that is easy because of simply a straight piece of metal stock with a flare at the end to hold the rubber hanger. We just had to measure and use weld through primer and then undercoat the section. It was then the best looking part of the frame.

Help restore a chevy

The product is outstanding and would recommended to all older Chevy drivers

Good fit!

Fit good came with good instructions

Full Reviews