Features:

  • 2" STANDAR FIT. This Heavy-duty square RV bumpers and accepts 2" cargo carrier and bike rack tubes
  • CAPACITY. 200Ib tongue weight, designed Specifically for 2" tube bicycle racks or cargo
  • ADJUSTABLE DESIGNE. It's for 4" or 4.5" continuous welded RV bumpers, the adapter takes 4 U-bolts and secures tightly around the travel trailer bumper
  • WEATHER RESISTANT. Finished in Powder coating provide durable and strong conditions, resist dust and corrosion, adds extra durability
  • PACKAGE INCLUDE. One adapter, 2 u-bolts and hardwares which is needed (pin is not include)
I’m an idiot.

It did bend the bumper on our camper, and after adding an extender to get it past the spare, and a bike rack, it bounced our bikes around so bad that it actually broke one of our gear shifters. That being said, none of that has anything to do specifically with the product. I can’t fault a product for being so strong that it bent our bumper, and what do you expect if you put bikes on the back of a 32 foot trailer that bounces around. Five stars for the product, one star for my stupid idea to haul expensive bikes on the back of the camper.

Well made and does the job.

This is a simple device so it seems it would be hard to mess it up. The built-in anti-wobble bolt is a nice touch as you don't need to buy a separate tightener to keep the cargo rack or bike rack from wobbling going down the road. The hardware is good quality and all the holes lined up correctly for installation.

Super strong and easy to install.

Super easy no drilling installation. I used this with a harbor freight cargo basket. I loaded the basket with a 270lbs of dirt bike and fuel. I backed up into tree and the cargo basket sustained damage. The hitch was so strong and rigid it was unharmed. Unfortunately my bumper bent and I can not remove my RV sewer hose from the bumper anymore. It appears that it is pinched right in the spot that the hitch was installed. The hitch worked perfectly even after my mishap.

HD material and dimensions "work"

This unit replaced an earlier cheaper brand sold via Amazon that was not dimensioned properly this unit works and easily supported our bike rack system & 2 bikes on our travel trailer (RV). Well made! Heavy material!!

Very sturdy and a great for our bikes

Installed in just a few minutes on the rear bumper of my camper. We used it for our bike rack to transport bikes for the kids to Florida. Worked perfectly!

Good for storing hitch when not in use.

Better built than I expected. I Installed this to store my load leveling hitch on my travel trailer frame when I'm at the camp site. You would need longer bolts if your frame is taller than 5 inches.

Use as support for an item in conjunction with the center hitch,

I purchased a Hollywood rack and attached these as outriggers behind my fifth wheel on that thin cheap bumper that holds a sewer line. Because I weld and fabricate as a hobby I made a stabilizer at each end of rack. I attached these to the frame and welded a plate under these for added support 1/4” thick by the width of the plate. Drilled some holes and voila.

I don't think I would use it to pull a trailer

It works just like it said it does it goes on easily seems to be strong enough I used to hold a carrier on the back of my camper

Heavy duty, solid construction.

I was very impressed with the heavy duty construction. Easy to install and is rock solid.

Good quality adaptor

Good Quality. I mounted to my tractor disk so I could use a two inch receiver mounted seed spreader

Full Reviews