Features:

  • Protects the vulnerable front radiators on your C8 Corvette
  • Precision cut from 1/16" thick aluminum, made specific for this vehicle
  • Quick and Easy Installation with supplied black cable ties
  • Durable Gloss Black powder coated finish
  • Rubber lined cutout for front trunk release on driver's side for easy access.
Great product, looks good, easy install

Great product, easy install. Thanks for having a YouTube video to show how it’s done and make it easy. It looks great and doesn’t block too much air. I took the museum delivery of my car down in Kentucky. I carried my grill covers on the plane and installed them The motel I stayed at. It’s a great looking product and it does the job. I don’t have any rock dents in my radiators

These are great. Don't get ripped off by other brands

They fit right and are metal, exactly like the inserts for airflow out of the engine compartment. So that is what they look like. The zip ties are a bear to put in at the top where you can't reach in and guide them. Bend the end of the zip ties and be patient. the small hole size makes it a bit difficult, but they protect better and make for a darker appearance -- looks great. there is a cutout for the frunk opener, but the rubber protector falls off. I used fishing line to tie it on. I belong to the mid-engine corvette forum and there is a manufacturer selling a similar product that mounts up front over the grill piece for over $300. Don't get it. These do the same thing and won't fall out or block your frunk opener. You might also put some good SiO2 wax or extra ceramic coating if you have some around, on them to make them wash off easier.

Patience and simples tools are all that you need!

Great quality finish on the grill. Just be careful of the sharp edges during install! Thankfully they included more than enough of high quality zip ties. Installed product looks clean as long as you zip tie in the right locations, you can't even see them. Job took about 1.5 hours mostly because of the 16-20 screws that you have to remove and reinstalled. Not difficult, just time consuming. If you have a car lift or ramp, you installation would be much easier...I just activated my front axle lift and that was sufficient. God help you if you don't have any of those methods to raise you car a little. Getting the grills in without bending them or damaging the fragile radiator was a challenge. Again, not too difficult, just work with you angle of entry and be patient! Overall, not a difficult mod...VERY please with how it looks and definitely will protect the radiator!

Great on quality, but installation takes time

Good quality and look great on my car. You could make your own, but materials and time would cost more. They're are not as quick to install as you would expect. Suggest using a modified dental tool hook to feed the zip ties back through the grill. Check out the Corvette Forum for great installation photos and advice. Can't imagine not using jacks or a car lift to do the installation.

Protect your Radiators!

This should be on every new C8 owners first upgrade list. Simple project requiring only a few hand tools. The precut screens fit well into the bumper openings, and the mesh pattern matches the rear diffuser grille giving it a OE look. Highly recommend this while your C8 is new before the radiators get dinged up by bugs and debris.

Great screens for protection

Nothing to dislike. Saves your radiator and a/c coils from rocks and insects. Well...not the little bitty insects. They won't do that again..

Get the car off the ground.

Tough to get your hands in there... It's better is you can raise the car.

Easy to install.

Installed on my 2020 Corvette as a rock guard.

very nice

Looks great, fairly easy to install. Wish maybe other grill openings were included.

Radiators now have guards against road debris that could have damaged them.

Fit is very good. Installation was performed by Chevrolet tech.

Full Reviews